We are very proud to announce our newest partnership with,

---

 This new mount allows you to attach Jecod ,Jeboa ,Tunze ,Sunsun,Aqqa Hygger ,if your wave maker has holes for the rubber mounts it will attach with nylon nuts and bolts to our Magnetless Mount 

This Bracket allows you to attach a magnetic wave maker to it but you can alter the angle of your wave maker to suit individual reef requirements .

Some wave makers are incredibly heavy and occasionally our disc isn’t enough to keep the wave maker in place ,in this instance we suggest an application of marine silicone on both the disc face and magnetic face and leave to cure over night .

The Magnetic mount is 3D encapsulated disc ( tested to 3 bar ) that will receive most magnetic wave makers ,it also comes with the solid drive rod that will fit to your hollow telescopic part of your drive shaft .This mount comes with every Seawave you purchase but can be bought as an optional extra .

This mount can be used in both the vertical face position as sent out from the factory or in the horizontal position so you can neatly hang your wave maker off it !.

Installation ,if your wave maker is rather heavy we advise that you dot two or three blobs of marine grade silicone on our disc and place your magnetic mount to our disc and leave to set over night ,some manufactures use a light grade magnet on the wet side of the pair of magnets .

As with all items that contain metal within them we recommend they are visually inspected every 4 weeks for any signs of degradation.

These Brackets are fully adjustable angle (even upwards ) with a simple adjustment you can now angle a Nero !!

The drive rods can be reduced in length with simply using a junior hacksaw .

The black rod is the only part of the drive assembly that comes with this accessory and will fit to your existing hollow drive shaft .

The Telescopic Drive rod allows you to select the right depth of water you want your wave maker to sit in ,the Drive shaft had been drilled at one end and a nylon black nut and bolt are used to secure it to the drive shaft that comes out of the Motor housing

To shorten the drive rod down remove the dark grey adjustable fitting from the grey outer drive shaft it will be tight but it is not glued !,cut this shaft with a junior hacksaw ,like wise you can cut the black solid drive to your desirable length .

NOTE : We advise not to have the drive rod assembly attached to the Motörhead when cutting because it will put unnecessary strain on the internal motor ,we also advise not to have the wave maker attached !.

 A frag rack that allows you to clip onto any ocean sea products 

 5V D.C Universal Transformer. Condition is New. power for any ocean sea products 

 This mount is a world 1st a back to back mount that would allow you to rotate two magnetic wave makers (of your choice) through 180 degrees and giving you 360 degrees water movement for those huge Frag and lagoon systems ( Wave makers are extra ).The drive rod can be reduced in length very easily by cutting it with a junior hacksaw.